ABSTRACT
Building ventilation significantly impacts healthy and safe indoor conditions preventing airborne virus spread between people. Therefore, ventilation strategy is a globally essential and health-promoting research topic. Previous studies showed the importance of sufficient ventilation for diluting the virus concentration and reducing the infection risk. The present study investigates the probability of coronavirus infection in the typical room calculated with the Wells Riley proposes recommendations for further research of indoor airflow effect on the virus transmission. © 2022 17th International Conference on Indoor Air Quality and Climate, INDOOR AIR 2022. All rights reserved.
ABSTRACT
This investigation presents results of Computational Fluid Dynamics (CFD) modelling of aerosol behaviour within an arbitrary 'realistic' 100m2 office environment, with dynamic and variable respiratory droplet release profile applied based on published findings (Morawska et al., 2009). A multitude of ventilation strategies and configurations have been applied to the base model to compare the effectiveness of reducing the concentration of suspended aerosols over time. A key finding of the investigation indicates a relatively low sensitivity to increasing outside air percentage, and that the benefit from this strategy is heavily dependent on the in-duct droplet decay factor. The application of local recirculating air filtration systems with MERV-13 filters mounted on occupant desks proved significantly more effectiveness than increasing outside air concentration from 25% to 100% in reducing the quantity of suspended aerosols. This highlights that the ventilation industry should perhaps focus on opportunities to integrate filtration systems into furniture, partitions, cabinetry etc., and that an appliance-based solution may be more beneficial for reducing COVID-19 transmission in buildings (and likely more straightforward) than modifications to central ventilation systems, particularly in the application of refurbishments and retrofits. © 2022 17th International Conference on Indoor Air Quality and Climate, INDOOR AIR 2022. All rights reserved.
ABSTRACT
The coronavirus disease may spread by airborne aerosols, especially in a poorly ventilated enclosure. Natural ventilation can reduce the transmission of infection. The WHO suggested the minimum ventilation rate of 10 L/s/person in non-residential settings. The objective was to evaluate risk of airborne infection with different settings in natural ventilated classroom. The risk was evaluated by using the modified Wells-Riley equation associated with the variation of contaminant concentration simulated by a multi-zone airflow model. The results provide the guidance of natural ventilation strategy in the classroom to reduce the transmission of airborne infection disease. © 2022 17th International Conference on Indoor Air Quality and Climate, INDOOR AIR 2022. All rights reserved.
ABSTRACT
As work environments struggle to reopen during the current COVID-19 pandemic, it is crucial to establish practical decision-aiding tools. While a strong emphasis has been placed on determining generic guidelines to reduce the risk of airborne viral spread, there is a lack of free and easy-to-use simulation workflows to quantify indoor air quality and the risk of airborne pathogens indoors at a spatial resolution that can take into account floor-plan layouts, furniture, and ventilation inlet-outlet positions. This paper describes the development of a new, free, early design tool that allows designers and other stakeholders to simulate and compare airborne viral concentrations under different indoor conditions. The tool leverages OpenFOAM-based Computational Fluid Dynamics (CFD) and a passive scalar simulation approach to allow architects and interior designers to quantify airborne pathogens' exposure. The tool is integrated into the popular Rhino3d & Grasshopper CAD environment to facilitate its application in fast-paced design processes. We demonstrate good agreement compared to a CFD benchmark test. Further, we validate newly developed COVID-19 capabilities by comparing our results to an existing restaurant case study that included tracer gas measurements and validation using Fluent (Ansys). We demonstrate applications of the tool in a comparative study of a restaurant that investigates how plan and furniture layout interventions, ventilation strategies can impact the movement of airborne pathogens in indoor environments. © International Building Performance Simulation Association, 2022
ABSTRACT
With the wide spread of COVID-19, numerous cases demonstrate that proper ventilation method can reduce the cross-infection risk obviously. Interactive cascade ventilation (ICV) as a recently proposed ventilation method, the advantage of indoor environment construction has been proven. However, few studies are conducted to investigate the virus prevention and control characteristics of ICV, which is particularly important under epidemic normalizing. Hence, this study explored and compared the cross-infection control performance of three ventilation strategies, namely mixing ventilation (MV), stratum ventilation (SV), and interactive cascade ventilation (ICV), with a validated CFD model. A typical office was selected as the background scene, where an infected person coughs, sneezes with standing or sitting at different positions. Exposure doses, health infection risk, and disease burden (DB) were employed as the evaluation indicators under different ventilation methods of multi-scenario. The research results indicated that the average aerosol exposure dose among the human respiratory region under ICV was 0.29 g/day, which was reduced by 67 % and 50 % compared with MV and SV. In addition, only in ICV can the health infection risk meets the EPA standard. The average disease health burden for exposed persons under ICV was 0.93 × 10−6 DALYs pppy, which was 37 % and 70 % lower than SV and MV. The findings obtained from this study confirm that ICV performs excellently in reducing the cross-infection risk, providing the theoretical basis for future epidemic prevention and control. © 2022 Elsevier Ltd
ABSTRACT
A proper ventilation strategy in an isolation ward could promote better indoor air quality for the occupants. This could also reduce the risk of immunocompromised patients contracting healthcare-associated infections (HAI) or airborne diseases such as COVID-19, tuberculosis, and measles among others. This study aims to propose and examine appropriate ventilation strategies in a single-patient isolation ward that can reduce particle settlement in patients. A simplified CFD model of the isolation ward was developed and well-validated against established data. An RNG k-ε model and discrete phase model (DPM) were used to simulate airflow and particle transportation. The study examined the airflow and particle dispersion under a baseline case and four proposed ventilation strategies. Results showed that the baseline case study, which used the ceiling-mounted air curtain was insufficient to prevent the particles from dispersing into the vicinity of the patient. Likewise, the dilution effect under the baseline case and case 4 (wall-mounted air supply diffuser) were relatively weak due to the low air change rate (ACH) of 4/hr and 9/hr respectively. The ventilation strategy in case 4 has a negligible effect on reducing the particles (14%) settling on the patient although the ACH in case 4 was 2-times the baseline case. The present finding ascertains that utilising the combination of ceiling-mounted air diffuser and air curtain jet (case 3) results in zero particle settlement on both patient's and the patient's bed. It also reduced 57% of particles in the vicinity of the medical staff's breathing zone compared to the baseline case. © 2023 Elsevier Ltd
ABSTRACT
A proper ventilation strategy in an isolation ward could promote better indoor air quality for the occupants. This could also reduce the risk of immunocompromised patients contracting healthcare-associated infections (HAI) or airborne diseases such as COVID-19, tuberculosis, and measles among others. This study aims to propose and examine appropriate ventilation strategies in a single-patient isolation ward that can reduce particle settlement in patients. A simplified CFD model of the isolation ward was developed and well-validated against established data. An RNG k-ε model and discrete phase model (DPM) were used to simulate airflow and particle transportation. The study examined the airflow and particle dispersion under a baseline case and four proposed ventilation strategies. Results showed that the baseline case study, which used the ceiling-mounted air curtain was insufficient to prevent the particles from dispersing into the vicinity of the patient. Likewise, the dilution effect under the baseline case and case 4 (wall-mounted air supply diffuser) were relatively weak due to the low air change rate (ACH) of 4/hr and 9/hr respectively. The ventilation strategy in case 4 has a negligible effect on reducing the particles (14%) settling on the patient although the ACH in case 4 was 2-times the baseline case. The present finding ascertains that utilising the combination of ceiling-mounted air diffuser and air curtain jet (case 3) results in zero particle settlement on both patient's and the patient's bed. It also reduced 57% of particles in the vicinity of the medical staff's breathing zone compared to the baseline case.
ABSTRACT
Under the global landscape of the prolonged COVID-19 pandemic, the number of individuals who need to be tested for COVID-19 through screening centers is increasing. However, the risk of viral infection during the screening process remains significant. To limit cross-infection in screening centers, a non-contact mobile screening center (NCMSC) that uses negative pressure booths to improve ventilation and enable safe, fast, and convenient COVID-19 testing is developed. This study investigates aerosol transmission and ventilation control for eliminating cross-infection and for rapid virus removal from the indoor space using numerical analysis and experimental measurements. Computational fluid dynamics (CFD) simulations were used to evaluate the ventilation rate, pressure differential between spaces, and virus particle removal efficiency in NCMSC. We also characterized the airflow dynamics of NCMSC that is currently being piloted using particle image velocimetry (PIV). Moreover, design optimization was performed based on the air change rates and the ratio of supply air (SA) to exhaust air (EA). Three ventilation strategies for preventing viral transmission were tested. Based on the results of this study, standards for the installation and operation of a screening center for infectious diseases are proposed.
ABSTRACT
Millions of people have been infected globally due to the prevailing COVID-19 pandemic and spread of the disease indoors has become a challenging issue. In this context, the study focused on modelling the trajectories of virus-laden aerosols in a study room by the computational fluid dynamics approach under four mechanically-driven ventilation strategies: cavity flow, displacement flow and two cases of mixing flow. Modelling was conducted by coupling discrete phase model with the continuous phase during simulations. Mixing flow - case 1 is proved to be the safest strategy as the virus-laden aerosols leave the room in a single-pass without exposing the occupants. In displacement flow and mixing flow - case 2 ventilation, aerosols get entrapped in the supply air stream, causing heavy circulation while exposing many occupants. The study opens up new avenues for an extensive analysis on establishing an optimal ventilation solution in order to mitigate the spread of COVID-19 indoors. Copyright © 2021 Inderscience Enterprises Ltd.
ABSTRACT
During the COVID-19 pandemic, many recommendations were made in the field of limiting the transmission of the SARS-CoV-2 virus, from which we can learn a lesson for determining ventilation strategies in strategic types of buildings (those whose closure during a pandemic is harmful to the economy, e.g., nurseries). The research was aimed at identifying recommendations in the field of ventilation and proposing a solution that would be applicable in existing buildings intended for the care of small children, and which would ensure the proper quality of the building environment, at the same time with low costs incurred by the owners. The outside air pollution (PM10) and the climate in winter (low air temperature) were also taken into account. A strategy was proposed based on the use of decentralized units, dedicated to single rooms, thanks to which the appropriate amount of air is supplied (per person), the air is cleaned and heated in the heat recovery exchanger. It has been shown that the use of heat recovery ensures that the costs of air heating will be significantly lower than during airing. The proposed solutions require two holes in the external wall with a diameter of 160-200 mm (depending on the number of people), which guarantees the technically possible application in existing buildings. The strategy provides suitable conditions for the functioning of nurseries, but can be used in many types of buildings, in cold and temperate climates, where airing of the rooms during winter is not possible, especially in the case of locations where the quality of outdoor air is very poor. The proposed strategy may be applied during a pandemic, but also on a daily basis, because by ensuring the proper quality of indoor air, young children will have healthy and hygienic conditions for development when they are not at home.
ABSTRACT
If noninvasive ventilation (NIV or high-flow CPAP) fails in severe cases of COVID-19, escalation of treatment with orotracheal intubation and intermitted prone positioning is provided as standard care. The present case reports show two COVID-19 patients with severe refractory hypoxemia despite NIV treatment during the first wave (first half year 2020) and the resulting influence on the treatment regimen during the second wave (since October 2020) of the pandemic. Both patients (aged 63 years and 77 years) voluntarily positioned themselves on the side or in a prone position without prior sedation and oral intubation. Positional treatment promptly improved the arterial oxygenation level. The oxygenation index improved in the following days with continued NIV and intermittent prone and side position. The recovered patients were transferred from the intensive care unit at days 5 and 14, respectively after admission. The case reports, along with other reports, show that prone or lateral positioning may be important in the treatment of SARS-CoV2 pneumonia in awake and not yet intubated patients.
Subject(s)
COVID-19 , Noninvasive Ventilation , Patient Positioning , Respiratory Insufficiency , Aged , COVID-19/therapy , Humans , Middle Aged , Prone PositionABSTRACT
Prefabricated inpatient wards have been proven to be an efficient alternative to quickly extend the caring capacity for patients. In this study, three typical ventilation strategies were studied using computational fluid dynamics in a prefabricated Coronavirus disease 2019 double-patient ward. Pollutants are the respiratory droplets and aerosols injected from two manikins. They are modelled as particles with different diameters (3 µm, 6 µm, 12 µm, 20 µm, 45 µm and 175 µm) by the Eulerian-Lagrangian model. Three ventilation strategies with an identical air change rate of 12.3 h-1 but different layouts of inlets and outlets are implemented. The flow field, flow structures and particle trajectories have been analysed and compared among the three ventilation strategies. The fate of particles is analysed and compared quantitatively. It is found that small particles (<20 µm) can move along with the main flow streams. Most of them are removed by ventilation to the outlet(s). Large particles (>45 µm) cannot move with the flow streams over a long path. Most of them deposit on solid surfaces in different regions of the ward in each ventilation strategy. Health workers should pay close attention to these polluted areas. Targeted cleaning of the polluted areas is necessary in a prefabricated inpatient ward. To promote the removal of some large particles (e.g., 45 µm) by the outlet(s), the outlet(s) should be installed inside the landing area of large particles and close to the polluted source(s).